Ask a Question

Can any of the 7 positions be selected for the RM35UA13MW under-voltage over-voltage measurement and control relay?

Only 1 of the 4 positions can be selected, such as:
either :
(1) < U No Memory
(2) < U Memory
(3) > U No Memory
(4) > U Memory

Whilst the electrical power is off, The Relay should be adjusted to:  < U No Memory
While using the RM35UA13MW to monitor for voltages less than 25 volts and without latching.
Also, it would be wise to monitor the sub-circuit first with a power analyzer to make
certain that the voltage variations on their site will be suitable for using the RM35UA13MW.

For further information refer to the attachment.
Was this helpful?
What can we do to improve the information ?