Ask a Question

What is the power output limitations of the L5501RFCP C-bus Sweep fan control?

The fan load rating must not exceed 1.5Amps.
The L5501RFCP C-Bus Ceiling Sweep Fan Controller unit is a DIN rail mounted C-Bus output device that provides speed control for a ceiling sweep fan. The Fan Controller uses multiple relays and a dual capacitor block for speed selection.
Some of its key features are:
  • C-Bus current requirement 18 mA, powered from C-Bus network, does not provide power for the C-Bus network
  • Maximum units per network 100
  • Network clock software selectable
  • Network burden Software selectable when Unit Address is 001
  • AC input impedance 100 kOhm at 1 k Hz
  • Warm-up time 10 s
  • Electrical isolation 3.75 kV from C-Bus to mains
  • Input voltage for fan motor 100 V AC to 240 V AC; input circuit must have a suitable circuit breaker
  • Fan load rating 1.5 A
  • Switch duty type (S1) Continuous duty. Line and neutral are switched. Fan motor and neutral are switched
  • Speed control Capacitive; capacitor block supplied by fan manufacturer for Low and Medium speeds. High speed uses direct on-line (no capacitor in the circuit). Three unique fan speeds Low, Med and Hi and Off
  • Connectors C-Bus: 2 x RJ-45
  • Capacitor block: 3 x push button for one 1.5 mm²
  • Fan: 2 x screw type for one 1.5 mm² wire
  • Input Power: 2 x screw type for up to two 1.5 mm² Indicators Unit, C-Bus, 3 x Fan speed
  • Control Local override pushbutton, not illuminated
  • Class of switch Class II
  • Rated impulse withstand voltage 4 kV
  • Proof tracking index (PTI) 175
  • Pollution degree 2
  • Glow wire test (GWIT) Level 3, 850° C
  • Mounting type DIN rail, or wall or ceiling space mounting in the optional plastic enclosure; For indoor use only
  • Operating temperature 0° to 65° C
  • Humidity 10 to 95% RH, non condensing
For further information please visit http://www.clipsal.com/Trade/Products/ProductDetail?catno=L5501RFCP
Was this helpful?
What can we do to improve the information ?