Technical FAQs

Ask a Question

What are the torque settings for the screws in the terminals for the Iconic sockets?

For the screws in the Iconic sockets, the torque settings should be as below as per Table 8.7 AS/NZS 3100:
  • All single GPOs 2Nm (M5 screw)
  • Twin horizontal GPOs without extra switch 2Nm (M5 screw)
  • Twin horizontal GPOs with extra switch 1.2Nm (M4 screw)
  • Twin vertical GPOs 1.2Nm (M4 screw)
  • All quad GPOs 2Nm (M5 screw)
Was this helpful?
What can we do to improve the information ?